Aligner C (MJB4)

About

SUSS MJB4 Mask Aligner C in Photo Bay

Process: This is a manual contact mask aligner designed for precise UV photolithography on small pieces or substrates. It offers high-magnification objectives for accurate alignment and supports standard contact modes, making it suitable for fine features on limited-size samples.

Hardware: 350 W mercury arc lamp with UV output in the 350–450 nm range (broadband UV). High-resolution optics including 10x eyepieces and objectives at 5x, 10x, and 20x for detailed alignment. Vacuum chuck for substrate and mask hold-down. Pneumatic controls for contact modes (soft, hard, vacuum – assumed standard for MJB4 series).

Key Features:

• Resolution: 0.8 µm (in hard/vacuum contact)
• Contact modes: Soft, Hard, Vacuum (standard for MJB series)
• Exposure wavelength: UV 350–450 nm (broadband Hg arc)
• Optics: Eyepieces 10x; objectives 5x, 10x, 20x
• Substrate size: Pieces up to 2"
• Mask size: 3", 4", and 5"

Applications:

• High-precision patterning on small pieces (e.g., test chips, prototypes)
• Fine-feature lithography down to ~0.8 µm
• Research and education on limited-size substrates
• Rapid process development with high-magnification alignment

Usage: Load mask and substrate, align using appropriate objective (5x/10x/20x), select contact mode, set exposure time/dose, expose, unload. Develop and inspect patterns post-exposure.

Detailed Specifications

• Model: SUSS MJB4 (Aligner C)
• Location: Photo Bay
• Substrate size: Pieces up to 2"
• Mask size: 3", 4", and 5"
• Resolution: 0.8 µm (optimal in hard/vacuum contact)
• Exposure source: 350 W Hg arc lamp, UV 350–450 nm
• Optics: Eyepieces 10x; objectives 5x, 10x, 20x
• Contact modes: Soft, Hard, Vacuum
• Features: High-magnification objectives for precise alignment, manual operation
• Other: Compact aligner optimized for small-substrate, high-resolution work

Documentation

• SOP – Standard Operating Procedure
• Training required – contact lab staff (Chandan Ramakrishnaiah or Shivakumar Bhaskaran)

Recipes & Data

• Standard Resists / Doses: Common settings include:

 * AZ/SPR positive resists: 50–150 mJ/cm² (adjust per thickness and mode)
 * SU-8 negative: Higher dose for thick films (e.g., 200–400 mJ/cm²)
 * Thin resists for 0.8 µm features: Optimize in hard/vacuum contact

• Process Control: Use 20x objective for critical alignment. Verify resolution and edge definition post-development.
• Notes: Smaller substrate size (up to 2") compared to MJB3 aligners. Use higher magnification objectives for sub-micron features. Clean mask after each use.

Template:Under review This article was generated with assistance from a large language model (LLM) and is currently under human review and editing. Content may contain inaccuracies, unverified claims, or other issues. Please help improve it.